Threaded View

Previous Post Previous Post   Next Post Next Post


  • HSE Notice: Weld Fume Reduction

    Hi All,

    After February's HSE notice about the change in enforcement around Welding fumes (particularly metal welding) we completed some monitoring around our own welding activities.

    We have a series of small spot welders on site for used to join some of our metal discs together. There is no surface coatings on the metal and this is a short contact (less than a second) and is some where between 4-10 weld spots per disc.

    The monitoring came back with minimal heavy metal content from lab results, however as it was observed that slight fumes where released from the weld the report has recommending introducing engineering controls.

    I think the only option to further reduce would be LEVS but this would be an expensive improvement due to the amount of spot welders we have and I was wondering if it’s reasonably practicable to do so when the report states the metal exposure concentrations are minimal? Is there anyone with more detailed knowledge around this? Spot welding in itself is already much lower risk than other forms but I don't want to leave the business open.

    Thanks in advance
    1
  • Hi All,

    After February's HSE notice about the change in enforcement around Welding fumes (particularly metal welding) we completed some monitoring around our own welding activities.

    We have a series of small spot welders on site for used to join some of our metal discs together. There is no surface coatings on the metal and this is a short contact (less than a second) and is some where between 4-10 weld spots per disc.

    The monitoring came back with minimal heavy metal content from lab results, however as it was observed that slight fumes where released from the weld the report has recommending introducing engineering controls.

    I think the only option to further reduce would be LEVS but this would be an expensive improvement due to the amount of spot welders we have and I was wondering if it’s reasonably practicable to do so when the report states the metal exposure concentrations are minimal? Is there anyone with more detailed knowledge around this? Spot welding in itself is already much lower risk than other forms but I don't want to leave the business open.

    Thanks in advance